Blade Liner Ran 103 Months With Zero Failures
October 13, 2026
Field Report The Job: Concrete recycling yard The Machine: Mining-class track dozer The Punishment: Large chunks of tear-out concrete hitting the blade, rebar dragging across the face, and broken concrete grinding at the surface on every push The Plate: Wear resistant CCO RaptorPlate® blade liner …
How to Install Wear Resistant CCO RaptorPlate®: Fillet and Plug Weld Procedure
October 13, 2026
.rpg{box-sizing:border-box;max-width:100%;border:2px solid #EB8734;border-radius:6px;padding:16px;margin:24px 0;display:flex;gap:18px;align-items:center;flex-wrap:wrap}.rpg-t{flex:1 1 240px}.rpg-t strong{display:block;font-size:1.15em;margin-bottom:4px}.rpg-t p{margin:0 0…
OEM vs. Aftermarket Mining Wear Parts: A Buyer's Guide
September 14, 2026
Every maintenance manager running a high-wear operation has asked the same question at some point: should we be buying OEM parts, or is there a better option? It sounds simple. In practice, it depends on what the operation is optimizing for, what the ore conditions look like, and whether the…
Five Years. Four Applications. One Liner Package.
September 2, 2026
Every wear plate salesperson will tell you theirs lasts longer. The question is: longer than what? A Yukon-based contractor put a 1/2" wear resistant CCO RaptorPlate® liner package on a large dozer blade and worked it for five years across four very different applications. Hard rock, placer …
Mining Chute Liners for Underground Applications
August 12, 2026
Underground conveyor chutes take a beating. High velocity material, tight geometry and impact zones eat through standard liners faster than the maintenance schedule allows. The wrong liner in the wrong spot does not just wear out, it creates unplanned downtime at the worst possible time. Raptor has…
HarderPlate® by Raptor for Mining, Quarry, and Heavy Equipment
June 30, 2026
HarderPlate® is Raptor's quenched and tempered abrasion resistant steel plate, engineered to take heavy impact and available in three hardness grades from 400bhn to 500bhn for mining, quarry, and heavy equipment across all makes and models. Wear plate fails one of two ways. It gets ground down, or …
Ground Engaging Tools (GET): Wear Points and When to Change Them
June 18, 2026
Ground engaging tools, usually shortened to GET, are the parts that touch the ground first. Teeth, adapters, shrouds and cutting edges take the abrasion so the bucket underneath does not have to. They are consumables by design. Every one of them is meant to wear out, and the question on any site is…
Bucket Inspection and Rebuild — Full Service Bucket Restoration by Raptor Mining
June 17, 2026
Bucket Inspection and Rebuilds by Raptor Mining — and in some cases, bucket inspection and rebuilds by a Raptor. A mining bucket takes constant punishment. Impact, abrasion, and structural stress add up over time and eventually every bucket needs attention. The question is whether you have a r…
Dragline GET — Selection and Wear Life Considerations for High-Volume Mining Operations
June 17, 2026
Draglines are among the most productive and capital-intensive machines in surface mining. A single dragline bucket can move enormous volumes of material every shift, and the ground engaging tools attached to that bucket are what make it possible. When GET wears out or fails, productivity stops.…
Bucket Lip Shrouds for Mining Excavators
June 17, 2026
The lip is the most expensive edge on an excavator bucket to lose. It takes impact and abrasion on every pass, and once it wears, the fix is a rebuild or a new bucket. Lip shrouds exist so that never has to happen. A bucket lip shroud sits over the lip between the teeth and takes the wear in its…